Anti-Corrosion Tubing Pump
Anti-Corrosion Tubing Pump
Sanjack Petro manufactures Anti-corrosion tubing pump in China. With locations in the Dongying City where is Shengli Oilfield located, this philosophy led us to become one of the largest and premier manufacturers and pump repair facilities in the China.
25 years Anti-corrosion tubing pump manufacturing experience
The strictest quality standards on Anti-corrosion tubing pump
Full support on your customised requirement
The pump with an anticorrosive oil well pump to enhance the corrosion resistance and impact resistance of the oil well pump and valve cover, and is suitable for oil wells with high salinity, easy corrosion and valve cover fracture.
For conventional oil well pumps, sand particles easily enter the sealing gap during the oil pumping process, causing wear of the pump barrel and plunger. Due to the sand scraping ring, the diameter of the sand particles in the well fluid passing through the sand filter screen is smaller than the size of the sealing gap, which will not cause wear on the pump barrel and plunger, and will not cause sand stuck; it is different from the sealing ring of the soft seal pump: the upper and lower ends of the The pressure is balanced, the positive pressure of the pump barrel is just its own elastic force. Hence less wear and longer service life.
1. Sand control: In the normal swabbing process, since the sand will not be deposited in the wedge-shaped gap at the oil outlet valve, there will be no sticky sand.
2. Long service life: Since the large-diameter sand cannot enter the gap between the pump barrel and the plunger, it will not wear the plunger and the pump barrel, the gap leakage is almost unchanged, the pump efficiency declines slowly, and the pump efficiency is high for a long time.
3. Simple structure, low cost, few wearing parts and low failure rate.
4. The construction operation is exactly the same as that of the conventional pump, and the operation and maintenance are convenient.
It is suitable for conventional oil wells with pump inlet temperature less than 100℃, sand content less than 0.5‰, and crude oil viscosity less than 3000mPa·S.
What Our Client Say About Sanjack Petro?
Be An Expert When Importing Petroleum Equipment
Check All Guides
OCTG Tubing Guide- Specifications and Grade of steel
- PSL1 or PSL2
- Corrosion and wear conditions
Steel Tubing Pipe Guide- Specifications and Grade of steel.
- PSL1 or PSL2
- Corrosion and wear conditions.
Vacuum insulated tubing Guide- Specifications and Grade of steel.
- The connection type.
- Working temperature.
Tungsten Coated Tubing Guide- Corrosive composition
- Abrasion condition
- Working temperature.